The disposal price has been reduced! (Member discounts are not applicable) 2024/3/7 sales price 398,000 yen Exterior maintenance completed! Replace network capacitors with SOLEN film capacitors. The unit is DENTECH Tune HDP385, and the enclosure is made by Shinkosha. The unit is attached by removing the back plate, and the net does not come off the front. Classical music also goes well with symphonies. The exterior is generally beautifully finished due to maintenance. Serial AYT71012 AYT71012 (Tomonori Asaine)
Maintenance information: 2024.3.7 Maintained (exterior repair/cleaning)
Rear baffle paint saran net replacement unit maintenance (exterior cleaning, low range center adjustment, screw tightening, high frequency magnetic circuit slit cleaning/center adjustment) ATT cleaning/knob adjustment unit detachment)
2015.5.14 Maintained (network capacitors replaced with SOLEN. Unit edge replacement. Magnetic circuit overhaul and operation adjustment. Saran net partial cleaning net tear repair, complementary color correction)
Accessories: none
Main specifications: used unit HPD385 frequency characteristics 20Hz to 20kHz allowable input 85W 92dB 8Ω W600 x H1075 x D380 mm approx. 42 kg/bottle
The price has been reduced. 2024/4/11 sales price 278,000 yen ※Saran net is out of stock. Edge has been maintained, including a brand new replacement! It is an improved model of the best-selling S3100, and inherits the technical know-how of the K2 series. The compression driver is 275 Nd, and the high range horn is equipped with a defined directivity horn. The woofer uses the ME150HS. In addition to the loud, voluminous bass, the clear high frequency, which is sharper than the original, is attractive. There is color burn on the center cap, dents and small scratches on the top surface. (MURAKOSHI Yoichi)
Maintenance information: 2024.4.10 maintenance (exterior cleaning/simple repair
Woofer edge replacement, driver maintenance (magnetic circuit gap cleaning/center adjustment, sound absorbing material replacement, replacement with a used product of the same type due to damage to one side+ terminal) unit detachment/9V battery replacement)
Accessories: instruction manual
Main specifications: 2 way 2 speaker usage unit/38cm woofer ME150HS, horn H2600-1, HF driver 275nd efficiency 95dB impedance 8 ohms dimensions W561 x H1102 x D406 mm weight 63.5 kg/bottle
Internal and external maintenance has been applied and brushed up. The vivid sense of dynamism and the sharpness of the high frequencies typical of YAMAHA have been revived. It has a low frequency thickness that 1000 monitors don't have. It is a timeless masterpiece with a clear sense of transparency, upper and lower driving force, and the smooth connection, and the heavy exterior with an ebony finish that stands out at a glance even today. It is in good condition due to maintenance. Serial 11478L 11478R (Yamato Yuki)
Maintenance information: 2024.4.1 operation confirmed
2023.9.4 Maintained (exterior repair/polishing/clear finish. Rear baffle repair/painting. Saran net replacement. Unit frame painting. Network maintenance (Since the terminals have already been replaced with external products, adjust the direction and tighten, apply a screw fastener, and replace the mounting screws. ATT contact status check (check that there are no gaps). A frequency characteristic measurement check (~ 42 kHz) was performed, and the original capacitor was continuously used because the results were good. Input/output waveform and balance check, sound output check) Unit detachable)
Accessories: saran net
Main specifications: 3-way sealed playback frequency band 40Hz to 20kH sound pressure level 90dB rated input 50W maximum allowable input 100W impedance 8Ω crossover frequency 500Hz/6kHz dimensions W395 x H710 x D349 mm 39 kg
Maintained. This is the X-2000R, the best model in the X series. It boasts performance that surpasses the X-1000R, such as a CA (cobalt amorphous) head and a newly designed equalizer amplifier, and you can listen to damped sounds with little noise due to the DBX installation. There are stains and bumps on the exterior. Serial 20066 (Tamura Eiji)
Maintenance information: 2024.4.18 Maintained (flywheel detachable cleaning and capstan shaft cleaning oil applied, capstan belt replacement, grease applied to the foot wheel stator bearing part. Pinch roller drive mechanical disassembly cleaning and grease application, pinch roller cleaning and pinch roller shaft oil application, tape pass check. Head cleaning and head azimuth angle check adjustment. Left and right impedance roller detachment fall cleaning and oil application, left and right tension arm detachment cleaning and cushion replacement, tension sensor cleaning, and tension roller shaft cleaning oil application. Reel stand tension adjustment (FWD/REV-PLAY winding tension and tension adjustment during FF/ REW) playback and recording AMP electrolytic capacitor check and partial replacement, meter lamp, DBX display lamp replacement, replacement procedure due to deterioration of power supply protection resistance. MIC, LINE, OUTPUT volume contact cleaning Contact cleaning by detaching and disassembling the monitor SW, REC mode SW, tape bias selector SW, and DBX SW. Playback level check and adjustment, recording level and vise check and adjustment, DBX amplifier level check and adjustment, recording and playback tests are excellent. Left and right legs missing additional reference value W&F during self-recording and playback (0.02% (WTD))
Accessories: clamper
Main specifications: 4-track, 2-channel stereo format, W432 x H456 x D268 mm, 21.0 kg
The disposal price has been reduced (member prices are not applicable). 2024/2/16 sales price 378,000 yen ※The power supply part has been newly created. Other internally deteriorated parts have been restored! 2-way 100Hz specification An electric crossover coveted by Mark Levinson fans. You can see how well the early Levinson was built can be seen from the feel of the knobs that seem to make you addicted. You can listen closely to Levinson's unique sounds even on Divider. The exterior has scratches on the front top plate and other threads (Mizusaki Ryo)
Maintenance information: 2024.2.16 Maintained (*Since there is no power source, new power supply and connection cable were manufactured, noise appears in the LChLow output, transistor defects in the low pass module were replaced, re-encapsulated, readjusted due to left and right level differences, 4 volume contacts were cleaned, specs were inspected, and blocking characteristics were inspected. The crossover is 100Hz)
Accessories: Power supply unit (newly created, non-genuine), power cable, copy of instruction manual
Main specifications: 2 way (100 Hz specification) closed module type RCA Remo input/output size (main unit) W483 x H51 x D156 mm 2.8 kg size (power supply part) W101 x H101 x D256 mm 2.2 kg
Internal maintenance etc. were overhauled in 2022/6! The appeal of 38 is that it has a sharp, thick tone that cannot be heard with current audio, and is surprisingly powerful. The thick mid range and soft, rounded high range are excellent compatibility with TANNOY speakers. There are some bumps and dents on the exterior. Serial 169796 (Yonejima Satoshi)
Maintenance information: 2022.6.1 Maintained (block capacitors and some electrolytic capacitors and film capacitors have been replaced. Also, some oil capacitors and vacuum tube sockets were replaced. Each part input/output inspection, rated output test (30W+30W when connected to a 1kHz 8Ω load), sound output check performed) 2016.12.6 maintained (back VR, volume VR, RCA terminal, SP terminal, coupling capacitor, SPSW, headphone jack, 9P socket, bypass cone, DCBAL, BIAS semi-VR deterioration replacement, adjustment, SW-class O.H, characteristic check OK)
Accessories: Power cable, copy of instruction manual
Main specifications: 30W+30W (4, 8, 16 ohms) line input 4 systems phono 2 systems (mm) W476 x H190 x D335 mm 18 kg