※1 bottle only. Speaker cable 2.0m is a standard BELDEN speaker cable nicknamed “sea snake” with an untreated end. The cable braided in orange and black is impressive, and features a tight sound (Murakoshi Yoichi)
Maintenance information: 2024.3.29 continuity confirmed
Accessories: none
Equivalent to the Hitachi DS-5T. Replacement needles for HRD-100 and HRD-101 It is unopened and operation has not been checked (Hiura Katsutsugu)
Maintenance information: operation unconfirmed
Accessories: none
Disposal prices have been reduced. Member discounts are not applicable. 2018/10/24 Sales price 3,000 yen These are parts made in Mexico whose details are unknown. There is rust, dirt, etc. (NAGAI Michio)
Maintenance Information: 2018.10.24 Conductivity Confirmed
Accessories: none
DP-1300M heavy headshell counterweight, set of 2 types, large and small A must-have item for those who use heavyweight cartridges such as SPU and FR. It can also be attached to the DP-500M. Recommended for those who use a variety of cartridges. There is slight dullness on the exterior (Murakoshi Yoichi)
Accessories: none
Main specifications: Compatible cartridges for their own weight/for 20 to 28 g (small) /for 26 to 37 g (large)
The original appeal of Arden, where a simple and beautiful design and deep sound coexist, has been revived due to full internal and external maintenance utilizing the original capacitors. This is the second generation of Tannoy's famous machine ARDEN. The warm and soft tone is attractive. It plays all kinds of music lusciously and gently. The sense of scale of the orchestra and the smooth playback of stringed instruments are satisfying enough to listen to. There are repair marks on the edge of the cone paper on one side and the top surface on one side. The exterior has been beautifully finished due to exterior maintenance. Serial 0016190/0005927 (Murakoshi Yoichi)
Maintenance information: 2024.4.3 maintenance (exterior repair) 2022.5.30 maintained (output terminal contact cleaning. Chassis screw replacement. Internal connection terminal (faston) replaced with a new one. ATT (SW type) contact cleaning. A frequency characteristic measurement check (~ 42 kHz) was performed, and the original capacitor was continuously used because the results were good. Check the input/output waveform and balance, and check the sound output. Unit maintenance (low range side: edge replacement, magnetic circuit rust removal/gap cleaning/center adjustment, high range side: magnetic circuit rust removal/gap cleaning/center adjustment. Exterior repair/polishing/oil finish Front and rear baffles/hakama repair/painting Saran net replacement. (Detachable unit)
Accessories: saran net
Main specifications: 2 way, 1 speaker, bass reflex system, floor type specification unit 3828, crossover frequency, 1 kHz, output sound pressure level, 91.5 dB, 8 ohms, dimensions W660 x H990 x D370 mm, weight 43 kg/book
A line selector that can be easily switched with an RCA connection. It can also be used for 4 input systems, 1 output system or 1 reverse input system, and 4 output systems, making it convenient to switch between multiple amplifiers and sources (Mizushima Itsuro)
Maintenance information: 2024.4.22 continuity confirmed
Accessories: instruction manual
Main specifications: 1 system/4 system input/output W160 x H65 x D95 mm 530 g
The flat characteristics make the sound good and are delicate. The sound quality is relatively thick among Audio-Technica models, and I like it without losing too much weight. The cantilever is slightly to the right. There is dirt and dullness (Hiura Katsuji)
Maintenance information: 2024.2.23 sound output confirmed
Accessories: none
Main specifications: mm type output voltage 4 mV needle pressure 0.75 to 1.75 g oval needle self weight 9 g
※Since there are no compatible cartridges, it has not been checked. Audio-Technica SP exclusive replacement needle. For those who use AT-3M, please use it as stock (Kobayashi Hitoshi)
Accessories: original box
Main specifications: 2.5 mil diamond needle, standard needle pressure 2 to 3 g
Audio-Technica mini jack to standard jack conversion plug The terminal part is gold-plated, and reliable conduction is achieved through reliable crimping through terminal shape research (Murakoshi Yoichi)
Accessories: none
※Only 1 speaker cable, 1.9 m terminal, is a cable with high sound quality and is easy to handle with an untreated titanium-containing sheath. There is a feeling of use such as dullness (Murakoshi Yoichi)
Maintenance information: 2024.4.11 continuity confirmed
Accessories: none
Digital cable 1.0m RCA terminal It uses a titanium-containing sheath, OFC (oxygen-free copper) wire, gold-plated contacts that are resistant to aging, and a sturdy metal pin plug with strong reliability. Good product with little feeling of use (Kanai Hidetsugu)
Maintenance information: 2023.7.20 Conductivity confirmed
Accessories: original box
Speaker cable with 1.7 m pair ends using unprocessed OFC. This cable is simple and easy to handle. There is a feeling of use throughout (Murakoshi Yoichi)
Maintenance Information: 2023.9.5 Conductivity Confirmed
Accessories: none