Everything from unit and network overhauls to exterior maintenance has been completely refreshed! This is a Lancaster equipped with a 12 inch monitor GOLD. The small feel of the high-efficiency 12-inch unit and the hole tone that sounds throughout the box are unique to this model. It sounds one size smaller than RECTANGLAR, and is compatible with tube amplifiers. There are some repair marks left, but the finish is beautiful. (FUJISAWA KOSHI)
Maintenance information: 2024.3.28 maintained (exterior repair/polishing/clear finish, rear baffle repair/painting, saran net cleaning/repasting, sound-absorbing material detachable, unit maintenance: magnetic circuit gap cleaning/center adjustment for both low and high frequencies, network maintenance: frequency characteristic check, ATT cleaning, terminal mounting processing)
Accessories: No accessories
Main specifications: 2 way, 1 speaker, bass reflex system, floor type, 12inch coaxial 2-way (MONITOR GOLD) frequency band 25 to 20,000 Hz minimum resonance frequency 20 Hz maximum input 30 W output sound pressure level 90.5 dB 8 Ω W535 × H840 × D320 mm 28.45 kg
Maintained. Vacuum tube stereo power amplifier. A bright, fresh sound typical of DYNACO. The middle range is thick and has a sense of temperature, and it sounds more powerful than I expected. This is an amplifier I want to play in combination with JBL, Altec, etc. The exterior has oxidation, rust, and line damage (Fujisawa Yukishi)
Maintenance information: 2024.3.28 Maintained (Electrolytic capacitors and AC cords replaced each due to deterioration. Rubber foot replacement. Solder correction. Vacuum tube pin cleaning. Remove foreign objects. Wiring restyling. Bias check. I checked the output sound. (Although it is AC117V specification, it can operate at AC100V.)
Accessories: No accessories
Main specifications: rated output 35W+35W vacuum tube EL34 x 4 7199 x 2 GZ-34 x 1 W330 x H165 x D240 mm 12.5 kg
Maintained by Electri, including replacing the windshield panel with a new one! A pre-main amplifier with a built-in McIntosh traditional output transformer. You can enjoy the rich and rich sound world typical of Macintosh. This is one that combines the sound appeal of modern and old McKinn. The sense of power that makes you feel the strength is similar to that of a separate amplifier. The exterior is dull. Serial JLF1440 (Fujisawa Yukishi)
Maintenance information: 2024.3.28 manufacturer maintained (windshield panel replacement. Replace the Oring to fix the switch bezel. Due to a problem with the operational amplifier, characteristics were poor, and the voltage was unstable, so a lot of pop noise was generated when the front volume display was off. IC exchange. Capacitors were replaced at various other locations. Replaced due to filter capacitor deterioration. Other relays, transistors, etc. have been replaced just in case, but please be aware that the pop noise of this unit is difficult to completely remove due to product specifications, so it can be heard slightly depending on when the power is turned on. Replace all front lamps. Lamp fixing grommet replacement. There is a difference in meter runout when the volume is low, but when the output is raised about 3/4, the difference is not very noticeable. Due to specifications due to individual differences in parts, improvements are difficult, so adjustments have been made so that they fit at a position of approximately half a meter. Same confirmation and other inspections.)
Accessories: remote control, instruction manual
Main specifications: 150W+150W (8/4/2Ω) phono input MM dimensions W445 x H179 x D508 mm weight 30 kg
Maintained! A control amplifier with a thorough review of the equalizer amplifier, which is important for record playback. It's perfect for those who want to make analog sounds moist. The retro look is also GOOD. The exterior has a feeling of use such as dullness and small scratches. Serial 111076 (Fujisawa Yukishi)
Maintenance information: 2024.3.7 maintained (rec function, tape monitor, gain, tape monitor, LOW HIGH filter, mode switch disassembly, polishing grease application, other volumes, switch cleaning, solder repair, power cord replacement, capacitor replacement, pin jack cleaning, operation check. (*The front pin jack input is fixed with rivets, so there is a lag ※When switching the impedance of the phono, the resistance value changes and the operation is normal, but there is not much change)
Accessories: none
Main specifications: phono circuit: MM2 system Phono 1:2.5 mV/50 kΩ Phono 2:2.5 mV/30 kΩ, 50 kΩ, 100 kΩ W410 × H170 × D270 mm 7 kg
*The lower front panel has been changed to a PRA-1003 panel. Maintained! A stereo power amplifier using a DC amplifier system. The power supply unit is equipped with 2 independent power transformers on the left and right sides. The powerful and clear sound emanating from the sturdy body is impressive! The well-designed analog meters are beautiful. You can enjoy all genres with very good extrusion and a sound that is not addictive. There are stains and small scratches throughout the exterior. Serial 110456 (Fujisawa Yukishi)
Maintenance information: 2024.3.7 Maintained (LR output meter relay replacement, LR power amplifier solder repair, differential circuit part FET, transistor replacement, pin jack replacement, interior and exterior inspection cleaning*Since the ceiling panel cannot be obtained from this unit, it remains the same)
Accessories: none
Main specifications: rated output 100W+100W (4Ω) 85W+85W (8Ω) transmission frequency characteristics DC to 100kHz W410 × H200 × D285 mm 17 kg