I features the technique of the saran net repair of the speaker in this week. KOSHIHAMA Yasuhito |
|
|
|
Peeling off of the adhesive is often seen in the speaker saran net of JBL4311 and ALTEC. There is no method because this comes off due to the aged deterioration. It causes the slack of the saran net when leaving it for a long time. It is necessary to often correct it. |
|
Let's prepare the adhesive and one tissue in the start. The tissue is wetting it to water a little. |
|
Let's dampen the part and the cloth of the tree in the tissue that wets it. This process is the purpose is done to make the instant adhesive react with water, and to make it bond quickly. |
|
It is damp extent. Let's keep moderate because it doesn't dry when wetting it too much. |
|
It is time when it uses the instant adhesive. It extends it thinly and widely as much as possible. However, let's make it quickly because it dries as it is when work is slow. Another point is to paint it thinly. When drying, it becomes white if it thick paints it. Please paint it thinly if it is so. The following process is only joined. |
|
It ended. After it dries it a little, let's use it. When a rubber system bond is used, processing hangs seriously time, and is not better finish. When the instant adhesive is used, it is possible to finish beautifully and quick because it sticks instantaneously, and the string is not pulled. The point is to dampen the cloth by water. It is not possible to bond by the instant adhesive's soaking into the cloth when not wetting it. Please note it. Please inquire in e-mail when questioning on other repair. KOSHIHAMA Yasuhito |