HiFiDo オーディオなんでも買います2

My treasure. Odd system bass June 10, 2005 Onmeijin Playback equipment has much combination and its installation environment is also of infinite variety. A fan is each thought and seems [ it ] that it is taking out pull an oar to the completely large sea. I have to take the course of "not neglecting the low-range showing the size of the sound" from experience of a live sound spot principle. And many things were rowed, and as a result of progressing, not only sufficient sound pressure extended on low-pass but the size of a pronunciation object turned out to be required so so. I wanted to get the quiet low sound of that contrabass or a bass drum in a hole. I also began from 16cm unit like the rest, and have used with 20cm, 30cm, and 38cm. I also used the boost circuit. Of course, from a space difference, although an impossible portion is also a certain reason, a few has come to touch fundamental low-range sound. The know-how which had not changed uniquely for a long time in the meantime was use of the good sealing box of a low-range sound. When I was young, the next door of the room that I listened to was a warehouse. This was the highest because the bordering wall was made into Baffle. I was in a tune and volume is raised. the floor of the kitchen which the back left was sounding, and I was scolded. Living environment changes and it is now impossible. If allowed, it will be good to set the next room to BOX. If middle and high is also attached to the next room by the reverse phase, I can listen to it by both rooms. It becomes 2 sets of stereos of highest bass.

It is the bass part of the present "system." A box is 110Hx70Wx50D externally. I took out the material table and had a material cut given to the two-by-four carpenter by part-time job. It was composed when I explained the above-mentioned assembly figure. Although it is the second floor, since 4-5cm concrete is put into the bottom of a floor, A sole plate is not attached to a box. It carries out for turning a rubberized carpet over (photograph red arrow). It has put on the appearance which turned down the bowl on it. Since an air seal is made by prudence, and a carpet side and a floor are slippery, I can do an assembly and installation movement alone.
The most effective of sound quality recently was making the main part of a speaker not vibrate. Although it was 30mm in baffle itself thickness, I reinforced and was surprised at the effect. Although mass is given, it is stubborn or there are various methods, I did the diameter of the square lumber of two-by-four to the box, as shown in a photograph. (Gray arrow). And I prepared the firm frame. I stopped SP Baffle earnestly with the screw to it. Low-range sank, and did not roll, and I could hear the anti-power when the wall of a hole shakes. And the reality of the crashing sound of timpani increased. Please devise and adhere Woofer more.
I am enjoying now, next it will be double woofer and I prepared 2 more Sansui. Since it is a multi-amplifier system, various units, such as a plane type, are built and I can enjoy, combining this freely. I think this is the royal road of pleasure of an audio. The younger should challenge as much as possible.

How was it? My system is "odd" too! Listening? Thank you.