Set of 5 LP/SP switchable replacement needle for Columbia PU-1270, PU-1280, and SPC-310 DTS-2 compatible Unopened, operation unconfirmed (Hiura Katsuji)
Maintenance Information: Operation Unconfirmed
Accessories: original box
The disposal price has been reduced! (Member discounts are not applicable) 2023/8/22 sales price 800 yen ※Quality cannot be guaranteed because deterioration due to long-term storage can be seen. Nagaoka replacement needles are compatible with COLUMBIA DSN-16 (Hiroki Aso)
Maintenance Information: 2023.8.24 Operation has not been checked
Accessories: case
The disposal price has been reduced. Member discounts are not applicable. 2024/4/13 sales price 128,000 yen ※The PHONO board is for MC only (MM cannot be used). Maintained! It has an elegant and glossy tone, and although combinations with 405 are common, 606 etc. are also a good match. It has the natural texture of the acoustic sauce and the smooth tone that feels good against the skin. There are small scratches and paint peeling on the right side. Serial 24151 (Takasaki Atsushi)
Maintenance information: 2024.4.12 maintenance (main board ground point screw reprocessing, operation check) 2024.1.17 maintenance (replacement of coupling C, bypass C, etc. in each board, AC SW spark killer C replacement, INPUT switching analog SW through hole pattern re-soldering, power SW internal contact polishing ~ operation check)
2020.6.13 Maintained (balance VR, SW disassembly cleaning. Attach 1 kΩ resistors to both the left and right sides of the flat board. Replaced due to faulty IC. All flat and mother boards have been soldered again. (Check the input/output waveform, check the left and right balance, and perform a comprehensive operation test by connecting the power amplifier to confirm normal operation.)
Accessories: power cord, copy of manual
Main specifications: 2 LINE inputs, 1 PHONO input, 1 phono sensitivity, 1m/3m/10mV switching, W321 x H103 x D203 mm, 4.0 kg
4530BK made by Shinkosha. Since there are many chips and scratches throughout, it is inexpensive. The D130 was mounted. Woofer with MA15 fastener! Powerful bass reproduction far exceeding size is possible with the rear loading horn type enclosure (Sasaki Shota)
Accessories: MA15
Main specifications: screw pitch 420 mm hole diameter 360 mm plate thickness 40 mm front baffle plate thickness 22 mm W600 x H1250 x D600 mm 56.3 kg (all measured)
Woofer fixing bracket MA15 included! An original product. A floor-type enclosure that uses a rear loading horn system. The interior has a folding horn structure with a total length of 2 meters, making it possible to reproduce powerful bass far exceeding its size. The exterior has chipped corners, scratches, repair marks, and paint peeling. Serial 11154 (Tomoho Asaine)
Accessories: MA15 woofer grill net
Main specifications: hole diameter 365 mm, screw pitch 420 mm backroad horn compatible speakers 2205, 2225, E140 minimum playback frequency 50 Hz main material particle board+Yonematsu laminated plywood (front baffle/road horn) W603 x H12 x D603 mm approx. 54 kg
※It has been repainted and is inexpensive because it is in poor condition. JBL original product. A floor-type enclosure that uses a rear-loading horn system. The interior has a folding horn structure with a total length of 2 meters, making it possible to reproduce powerful bass far exceeding its size. The exterior is scattered with chipped corners, scratches, and dullness. Shipping costs will be estimated separately (Mizusaki Ryo)
Accessories: screws
Main specifications: hole diameter 365 mm, screw pitch 420 mm backroad horn compatible speakers 2205, 2225, E140 minimum playback frequency 50 Hz main material particle board+Yonematsu laminated plywood (front baffle/road horn) W603 x H12 x D603 mm approx. 54 kg
XLR female to mono mini jack cable 4.5m unusual combination microphone cable. Can also be used as a normal microphone cable using standard jack conversion (Murakoshi Yoichi)
Maintenance information: 2024.4.11 continuity confirmed
Accessories: none
The disposal price has been reduced! Member prices are not applicable. 2022/7/16 selling price 100,000 yen wooden 46cm double woofer type. Baffle opening diameter 425mm Screw pitch 490mm Baffle and enclosure plate thickness 24mm Duct opening diameter 108mm Both the front and back plates cannot be removed. There is a difference in discoloration on the left and right in appearance, and there are corner chips, digging scratches, and dirt stains. (Yutaka Takimoto)
Accessories: none
Main specifications: W1600 × H950 × D850 mm (actual measurement) The weight has not been measured, but it seems that it is 100 kg or more.
Victor DTS-2 compatible Replacement needle for DTS-2 and STS-2 Operation not confirmed (Murakoshi Yoichi)
Maintenance information: operation unconfirmed
Accessories: original box
The price has been reduced! 2024/3/31 sales price 1,000 yen exchange needle for Nagoya. This is a Victor DT-ZL1S compatible product. Since there are no compatible cartridges, they have not been checked. *Quality cannot be guaranteed due to deterioration due to long-term storage (Takahashi Nobuyuki)
Maintenance information: 2024.3.31 unchecked
Accessories: case
Disposal prices have been reduced. Member discounts are not applicable. 2022/5/23 sales price 300 yen. ※Only 1 speaker cable uses oxygen-free copper (OFC) as the unprocessed conductor at the 0.5m end. The sound quality is relatively flat, so you can easily feel that the sound quality is a notch higher (Kanai Hidetsugu)
Maintenance information: 2022.5.22 Conductivity confirmed
Accessories: none
※Only 1 speaker cable, 0.9 m, has an orthodox cab tire structure, and reproduces sound quality that is thicker than the price. There is a feeling of use (Kobayashi Hitoshi)
Maintenance information: 2023.5.22 Confirmation confirmed
Accessories: none
Self-made enclosure. The woofer opening is about 340 mm in diameter, the horn opening above it is 450 mm x 266 mm, the upper opening is 260 mm x 134 mm, and the tweeter part is about 60 mm in diameter. Shipping costs will be estimated separately (Oikawa Tetsuji)
Accessories: none
Main specifications: plate thickness 25 mm W800 x H960 x D580 mm 54.1 kg (actual measurement)
A subwoofer designed to match the company's 6010B. It offers powerful sound that is unimaginable from a compact body. By connecting the sound source to the 5040B, it is possible to control the volume of the entire system with the included VCA type volume controller. There are a lot of abrasions overall. Serial PM11000555 (Fujisawa Yukishi)
Maintenance information: 2024.4.14 Operation confirmed
Accessories: remote control, power cord
Main specifications: output 70W W300 × H250 × D300 mm (actual measurement) 6.2 kg (actual measurement)
※1 unit only. Maintained! It is originally a professional mono amplifier, but there is only 1 unit. You can feel the strong power of the sound quality even with just one unit. It seems to be useful for mono and center speakers. The exterior has scratches and paint bald spots. Serial Q001769 (Fujisawa Yukishi)
Maintenance information: 2024.4.19 Maintained (XLR speaker cable created (3 meters), electrolytic capacitor replaced, cleaned due to ATT stiffness, solder corrected, rubber foot added due to missing rubber feet, bias offset check, output sound check. Input ① GND ② HOT ③ GND (unbalanced) output ① not used ② is set to plus ③ minus 8 Ω load. (Also, a popping sound is made when the power is on and off, which is a specification.)
Accessories: speaker cable, power cable
Main specifications: 8 ohms W482.6 x H88 x D320 mm weight 13 kg
The price has been drastically reduced. 2024/3/2 sales price 99,800 yen Maintained! professional monitor amplifier It has strength unique to commercial use, and the driving power in the low range is truly remarkable. However, it also has a strong sense of temperature typical of a quad, so it is an amplifier that I would like people who are shunned when the sound is too straight for commercial use to try it once. You can see a feeling of use, such as appearance, dullness, abrasions, etc. (Kobayashi Hitoshi)
Maintenance information: 2024.3.2 maintained (internal dismantling all check, Tr, C, R check, ±B INPUT bypass C replacement, Tr, R, etc., all OK, INPUT photocoupler check, operation check)
Accessories: copy of instruction manual, power cord, dedicated SP cord (cable length 2.5 m)
Main specifications: 100W+100W (8Ω) W483 × H88 × D310 mm 12.5 kg
1 sold bi-triode power tube made in the USA JAN measurement value 58 (rejection value 40) with original box ※ Measured value is gm value measured by tv-7 tester (Yosuke Kojima)
Accessories: original box
Pair Tube Bi-triode Power Tube Made in USA JAN Measurement Value 60/60 (Rejection Value 40) With Original Box ※ The pair is judged based on GM value measured on the tv-7 test machine (Yosuke Kojima)
Accessories: original box
Pair Tube Bi-triode Power Tube Made in USA JAN Measurement Value 60/60 (Rejection Value 40) With Original Box ※ The pair is judged based on GM value measured on the tv-7 test machine (Yosuke Kojima)
Accessories: original box
Pair Tube Bi-triode Power Tube Made in USA JAN Measurement Value 60/60 (Rejection Value 40) With Original Box ※ The pair is judged based on GM value measured on the tv-7 test machine (Yosuke Kojima)
Accessories: original box
XLR5pin/XLR3pin x 2 conversion cable 0.3 m NC5MXX-B/NC3FXX-B x 2 cable part: BELDEN 1172A There is an abrasion on the sheath (Kojima Yosuke)
Accessories: none
※One piece only. Details unknown, this is an ALTEC 604 or ALTEC 1 inch driver diaphragm. It seems to be an inexpensive interchangeable product (Daiki Goto)
Accessories: none