Fully maintained, including deteriorated condenser, vacuum tube replacement, and tone volume dismantling and cleaning! It is the fourth model in the 38 series, the successor to the FD. The sound with a good view not found in the early Luxman models is attractive. Of course, it is compatible with TANNOY, but it is also compatible with speakers that have a hard sound, such as YAMAHA monitor speakers. *The pilot lamp has been changed to LED (Murakoshi Yoichi)
Maintenance information: 2026.7.15 Maintained (main amplifier section driver circuit replacement of 8 semi-fixed VRs and replacement of 4 partial electrolytic capacitors, 50CA10 bias adjustment, drive amplifier plate voltage balance adjustment. Drive circuit resistance correction. Replace 8 phono equalizer circuit and tone flat circuit cathode bypass capacitors. Disassembly and cleaning treatment for each volume and toneon/off switch contacts of the tone control unit bass and treble, and preparation and installation of SW damaged parts. Disassembly and cleaning procedures for each contact point of the lever switch, selector switch, and mode switch. Main & Balance volume contact disassembly cleaning treatment, RecordingSW, -20dB ATTSW contact disassembly cleaning treatment. 4 parts were replaced due to diode deterioration in the 460V power supply circuit. Pilot lamp LED conversion procedure, AC power cable replacement. Remove rust from the sub-panel, paint, and replace 2 deteriorated fuses. Input terminal (PIN jack) holding force adjustment Tone flat amplifier section vacuum tube 12AU71 replacement, sound output test)
Accessories: instruction manual
Main specifications: 30W+30W vacuum tubes 50Ca10/4, 6AQ8/2, 6267/2, 12AX7/3, 12AU7/1, Frequency characteristics 30Hz to 40kHz W440 x H162 x D343 mm 20.1 kg
Tubing premain using KT88. This time it's equipped with GOLDION! A modern machine that combines the characteristics of modern tube amplifiers with good sharpness and a high sense of SN with a warm tone. The design, which combines style with the classic form of tube amplifiers, is also attractive. There are small scratches and abrasions in places (Oikawa Tetsuji)
Maintenance information: 2026.7.14 Operation confirmed
Main specifications: AB grade push pull 45W+45W vacuum tube KT88 x 4, 12 AU7 x 2, 12AX7 x 1 headphone terminal equipped, input RCA4 system, compatible with 6 to 8 ohms, W330 x D280 x H150 mm, 15 kg
This item is currently for sale. A vacuum tube hybrid premain amplifier manufactured by Luxman that was sold from the Mook book series of Ongakunotomosha Stereo magazine. The pre part has a hybrid configuration of 12AU7 vacuum tubes and the power part is an A/B grade analog amplifier. Recommended as an introduction to tubular amplifiers (Daiki Goto)
Maintenance information: 2026.7.9 operation confirmed
Accessories: power cable, catalog, AC adapter
Main specifications: output 5W+5W (4Ω) input RCA2 system W180 × H80 × D90 mm 700 g (actual measurement)