Payment and point member | Payment methods | Shipping methods | Warranty policy | Shopping procedure
- All
- All hardware
- All software
- Network players
- Integrated amplifiers
- Integrated amplifiers (transister)
- Integrated amplifiers (tube type)
- Control amplifiers (transister)
- Control amplifiers (tube type)
- Power amplifiers (transister)
- Power amplifiers (tube type)
- Channel dividers
- Tuners
- Other amplifiers
- Channel divider boad
- Speakers (foreign companies)
- Speakers (Japanese companies)
- Full range units
- Woofers
- Drivers
- Tweeters
- Horns
- Enclosures
- Networks
- Speaker accessories
- Turntables
- Tonearms
- Step-up transformers
- Head amplifiers
- Phono equalizers
- Cartridges
- Headshells
- D/A converters
- DAT decks
- MD players
- LD players
- DVD players
- CD players
- CD transports
- Cassette decks
- Reel-to-reel decks
- Other tapes
- Accessories
- Cables
- Insulators
- Racks
- Parts
- Tubes
- Manual
- Audio set
- Other audio
- LP jazz
- LP jazz vocal
- LP classic
- LP foreign music
- LP Japanese music
- Single records
- SP
- Other records
- Other soft
- Reel-to-reel tape
- Reel-to-reel tape jazz
- Reel-to-reel tape classic
- Other reel-to-reel tape
- Blank cassette tapes
- Laser disk
- DVD
- VHS
- Laser disk jazz
- Laser disk classic
- Other laser disk
- Laser disk movie
- CD jazz
- CD jazz vocal
- CD classic
- CD foreign music
- CD Japaese music
- Single CD
- Other CD
- Magazines
- STEREO SOUND
- MJ
- Other books
- Swing journal
- STEREO SOUND EX
- TUBE KINGDOM
- TAPE SOUND
- analog
- AUDIO ACCESSORY
- AUDIO PLAN
- AUDIO CRAFT MAGAZINE
- AUDIO BASIC
- JAZZ CRITIQUE
- stereo
- FM fan
- RADIO TECHNOLOGY
- RG
- description
- Maintained! A popular 2-way 500Hz network. It's an essential network for 2" drivers. In addition to a 3-position attenuator, it is equipped with a high frequency boost switch. It is very effective when constructing a 2-way system with a JBL 2441 driver, etc. The sound has also become fresh due to terminal rust removal (acid washing) treatment and insulation bushings and mounting screw replacement. There is a feeling of wear and small scratches over time (Teramoto Hidehiko) Maintenance information: 2023/12/17 maintained (terminal rust removal (pickling) treatment, insulation bushing & mounting screw replacement. ATT (SW type) contact cleaning. Reinforced so that the coil fixing inside the housing does not come off. Frequency characteristics measurement checks (~ approx. 42 kHz) were performed, and the original capacitors were continued to be used for good results. (Check input/output waveforms and balance, check sound output) Accessories: none Main specifications: crossover 500Hz low range 8Ω high range 16Ω high frequency level control 6/8/10dB 1.9 kg
- description
- ALTEC network. Crossover:500/800/1,200Hz. Maintenance completed on Oct.10 2011. Exchanged to Dayton film condensors.
Manufacture:JBL
Price: JPY 68,182(pair)Sold Out
- description
- JBL network. Crossover:1,200Hz. Maintenance completed on Feb.5 2012.
- description
- Professional cross 800 Hz network. It's an exhilarating sound with a great vantage point. How about making a 2-way horn system with a 16 ohm unit? There are stains and rust on the main body. Serial 7293/8121 (Satoshi Yonejima) Maintenance Information: 2021.6.28 Maintained (Terminal Rust Removal (Acid Wash) Treatment, Cleaning, Insulating Bushing & Mounting Screw Replacement. The adhesive fixing of the coils inside the housing is reinforced with silicon. ATT (SW type) contact cleaning. A frequency characteristic measurement check (~ approx. 42 kHz) was performed, and the original capacitor was continuously used for good results. Input/output waveform and balance check, sound output check) Accessories: no accessories Main specifications: crossover frequency 800 Hz impedance 12 to 16 ohms W122 x H154 x D132 mm 1.9 kg/1 unit
- description
- Maintained! A type with few exhibitions! Crossover 800Hz network. It is an indispensable gem for 2-way systems. There is a feeling of use, Kusumi, small scratches (Sasaki Shota) Maintenance information: 2020.5.19 Maintained (terminal rust removal (pickling), cleaning, insulation bushing & mounting screw replacement. ATT (SW type) contact cleaning The fixing of coils, etc. inside the housing is reinforced with silicon. Frequency characteristic measurement check (~ approx. 42 kHz) is performed and the original capacitor is continued to be used for good results. (I/O waveform and balance check, sound output check.) Accessories: None Main specifications: Impedance/bass range 8Ω, treble 16Ω crossover 800Hz high frequency boost 3-stage switching
- description
- Maintained! A rare 800 Hz/8 ohm network that doesn't arrive easily. The low frequencies are smoothly pushed out, and the clarity of the mid and high frequencies is enhanced. This network is recommended for those considering using a 2-way driver configuration. For LE175 and LE85 users You can enjoy a horn sound that is a bit different from 500Hz. Overall, there is a feeling of use over time. (TERAMOTO Hidehiko) Maintenance information: 2023/12/21 maintained (terminal rust removal (pickling) treatment, insulation bushings & mounting screws replaced. ATT (SW type) contact cleaning. Reinforced so that the coil fixation inside the housing does not come off. A frequency characteristic measurement check (~ 42 kHz) was performed, and the original capacitor was continuously used because the results were good. (Input/output waveform and balance check, sound output check) Accessories: none Main specifications: impedance 8 ohms, crossover, 800 Hz, 120 W, 3-stage gain control, approx. 1.9 kg
- description
- Maintenance completed in Nov.2009. 250W, 16 ohm. Crossover:500Hz. W28xH30.5xD13.7cm. 8.1kg.n
- description
- rare! Altec's 2-way division network can be switched between 500 Hz and 800 Hz. A product that can be used not only with the A7 but also with other systems. The impression is glossy, while keeping the sense of openness typical of Altec intact. There is an appearance, dullness, and small wounds (Kobayashi Hitoshi) Maintenance information: 2023.9.17 Maintenance completed (frequency characteristics check, ATT cleaning) Accessories: none Main specifications: 8Ω W191 x H114 x D225 mm with 500 Hz/800 Hz switchover 1.25 kg
Manufacture:ALTEC
Price: JPY 63,636(pair)Sold Out
- description
- ALTEC network. 2way. Crossover:500/800/1200Hz(Variable). Our maintenance completed in Dec.2010.
- description
- "Cut the price to 9,000・Singnature model(Gray)・16 ohms・Crossover 1200Hz"
- description
- The price has been reduced! 2020/9/21 Selling price 75,000 yen maintained. It is a network used for A5, A7, etc. Unlike channel dividers, it is easy to handle and sounds familiar to your ears. Appearance is scratched, dull. Serial 30386, 30733 (Asaine Tomoho) Maintenance information：2020.9.21 Maintenance completed (pickling input terminals and screws Rust removal cleaning output terminal solder removal ATT disassembly contact cleaning contact grease application frequency characteristics (Measurement check (~ about 42kHz) and continue to use original capacitor for good results Input/output waveform and balance check sound output check) Accessories: None Main specifications: Crossover 500Hz 8Ω W123 × H140 × D132mm 1.6kg
- description
- The price has been reduced! 2019/11/24 Selling price 75,000 yen Maintained! It is a cross 800Hz network that is very useful. The impression is that the low frequencies are pushed out smoothly, and the clarity of the mid-high frequencies is improved. It is a network that is useful for making a 2-way system that gives the woofer a certain amount of space. The exterior has a feeling of use and small scratches.. Serial 11409/11812 (Kei Otani) Maintenance information: 2019.11.24 Operation confirmed 2015.6.15 Maintained (terminal polishing, cleaning, insulation bush replacement, SW ATT cleaning, input/output waveform and balance check, sound output check, frequency characteristic measurement check/ ~ approx. 42kHz) Accessories: none Main specifications: Crossover frequency 800 Hz Impedance 12 to 16 Ω W122 × H154 × D132 mm 1.9 kg/1 unit
Used
Consigned
Hold
Reserved
Sold Out-
-
- Company profile
- Privacy policy
- Contact
- Newsletter back issues
- Hi-Fi Do live camera!
- Today's software
- Today's hardware
- New arrival alert system
- Japanese
-
Hi-Fi Do Online Newsletter
-
Payment methods
-
Shipping methods
-
Warranty policy
-
Shopping procedure
-
Hi-Fi Do Record Shops Softs, Audio parts and Tubes can ship overseas.Ordinary,we use EMS but for large order,we use SAL or Surface.For Asia,it cost 1,200JPY/1LP,900JPY/1CD.Please check at the shipping cost table for more detail.
-
Meaning of icons
