Maintained! It is a 2-way specification of a crossover 350Hz. A 2way/3way channel divider that allows you to change the crossover by replacing the board. Attenuation characteristics can be switched between -12 dB and -18 dB/oct. (Sasaki Shota)
Maintenance information: 2022.2.15 Maintained (push switch each replacement ATT disassembly cleaning foot mounting card edge contact cleaning. Fixed magnet catch disconnection. Crossover frequency characteristics and each input/output operation check. (I cleaned the interior and exterior.)
Accessories: Instructions
Main specifications: 350Hz/2way specification Frequency characteristic (single channel equivalent band) 20Hz to 20kHz Slope characteristic -12dB/oct, -18dB/oct, -24dB/oct switch changeover W445 × H109 × D373mm 9.1kg
The price was reduced. 2021.5.11 sales price 64,800 yen Accuphase channel divider. 2WAY board with 70Hz board It's currently low frequency like a superwoofer crossover. You can change the crossover by replacing the board. It is one of the few channel dividers that allow you to enjoy multi-system with an analog feel. Appearance has small scratches and dullness corresponding to the year (Oikawa Tetsuji)
Maintenance Information: 2021.5.11 Maintained (ATT Coupling Condenser Mute Relay Each Degradation Replacement Rubber Foot Mounting Panel End Cap Replacement Installation Solder Crossover characteristics check, each input/output operation check interior and exterior cleaned.)
Accessories: Power cable, manual copy
Main specifications: 2way · 3way divider frequency fixed W445 × H109 × D373mm 9.1kg
3way specification with 650Hz/7000Hz! Channel divider for AccuPhase 2way/3way You can change the crossover by replacing the board. It is one of the few channel dividers that allows you to enjoy a multi-system with an analog feel. There are dirt, and small scratches on the exterior (Sasaki Shota)
Maintenance Information: 2022.2.15 Maintained (Output ATT, Mute Relay, Coupling Capacitor, Resistor Each Replacement. We replaced wires, etc., corrected the remodeling, checked the frequency characteristics, and cleaned the interior and exterior. )
Accessories: manual, power cable
Main specifications: 650Hz/7000Hz 3way specification 2way/3way divider frequency fixed type W445 × H109 × D373mm 9.1kg
The disposal price has been reduced! (Member discounts are not applicable) 2021/6/11 sales price 79,800 yen It has been maintained, but there are times when some of them appear in the VOL of HI PASS Hz CH 1, but this is the current situation That's it. Crown's 2-way variable channel divider All filters can be continuously variable from 20Hz to 20kHz, so you can set the optimal crossover frequency while producing sound from the speakers. It can be used as a 2-way divider when using stereo, and as a 3-way divider when using mono. There is a feeling of use. Serial 5435 (Takasaki Atsushi)
Maintenance information: 2021.6.11 maintained (each SW, VOL cleaning, left and right level difference ±1dB → error of VOL itself (please adjust with input level VOL on the rear panel) (HI PASS Hz CH 1 VOL bad contact, there are times when crumbs come out (VOL not available, not compatible) It is not possible to respond if it is defective in the future)
Accessories: English manual, 6 phone jacks
Main specifications: Frequency characteristic 20Hz to 20kHz ±0.1dB (flat position, rated output) Filter 18dB/oct (high-pass and low-pass are separated) SN ratio 113dB (20Hz to 20kHz Impedance Unbalance: 0 to 15.5 dB 10kΩ or 1mΩ Balance 20kΩ Power Consumption 2W Dimensions W483 × H90 × D133 mm Weight 2.7 kg