High output MC cartridge for mono LPs only. Plays deep sound that was not produced with stereo cartridges. It has the vividness unique to Technica, but the three-dimensional effect and intensity are an appeal unique to mono (Murakoshi Yoichi)
Maintenance information: 2024.6.2 sound output confirmed
Accessories: needle cover, original box
Main specifications: high output MC type output 1.2 mV needle pressure 2.0 g impedance 40 ohms dead weight 6.8 g
2.0m PSE standard power cable with a diameter of 11 mm with an OFC conductor held tightly with a PVC sheath. It is a cable with excellent cost performance, with rhodium plating on both the connector and plug (Murakoshi Yoichi)
Maintenance information: 2024.6.2 continuity confirmed
Accessories: none
*Currently sold. DENON's MC type cartridge boost transformer. Since it is equipped with a pass circuit, it is convenient when listening by exchanging 2 types of cartridges (MM type, MC type) with a single arm. Also, since it uses a transformer designed for the DL-103 and DL-103S, it fully demonstrates the capabilities of the models described above. You can see the exterior, dullness, rust, and feeling of use (Kobayashi Hitoshi)
Maintenance information: 2024.5.5 operation confirmed
Accessories: none
Main specifications: primary impedance 40 ohms secondary impedance 4 kΩ boost ratio 1:10 frequency band 20 to 40 kHz dimensions W51 x H53 x D181 mm weight 0.65 kg
A classic MC boost transformer. With 2 input systems, an impedance of 3.40 ohms switchable, and a PASS line, you can freely enjoy a variety of cartridges and tone arms. There is an appearance, dullness, and a feeling of use (Kobayashi Hitoshi)
Maintenance information: 2023.11.18 Operation confirmed
Accessories: none
Main specifications: MC boost transformer input, 2 systems, switchable, 1st order impedance 40 Ω, 3 Ω, switching, 2nd order impedance 4 kΩ, boost ratio 1:10, frequency characteristics, 10 Hz to 100 kHz, W97 x H65 x D155 mm, 800 g
Maintained! The thickness of the mid range and the thickness of the low range are an exciting masterpiece pre-main. The special phono part uses a transformer for built-in MC boosting. Compared to lower models, it combines the politeness of being able to enjoy classical music. Appearance, dullness, abrasions, and a feeling of use can be seen (Kobayashi Hitoshi)
Maintenance information: 2024.6.2 maintained (tone switch and other switches dismantled and polished, coated with grease (subsonic, loudness, muting, input selector, reckout), output relay, headphone relay replacement, main amplifier transistor, adjustment volume replacement, solder and board repair, balance volume replacement, each volume, switch cleaning, interior and exterior inspection cleaning, adjustment, operation confirmation)
Accessories: copy of instruction manual
Main specifications: 130W+130W (8Ω) PHONO (MM/MC) 2 systems W460 x H160 x D444 mm 18 kg
Maintained! A late model in the classic 607 series. It has high-resolution, well-defined sound, and is compatible with modern speakers. You can experience SANSUI's ability. You can see a feeling of use, such as appearance, dullness, abrasions, etc. (Kobayashi Hitoshi)
Maintenance information: 2024.6.11 maintenance completed (protector circuit capacitor replacement, output relay replacement, phono and pin jack polishing, input selector, etc., switch disassembly polishing grease application (power amplifier direct, source direct, tape, tone, loudness, muting, processor switch), each volume, switch cleaning, internal inspection and cleaning, adjustment inspection, operation confirmation, running test)
Accessories: instruction manual (copy)
Main specifications: 105W+105W (6Ω) 90W+90W (8Ω) phono MM/ MC switching W430 x H162 x D452 mm 18 kg
Maintained! A premain amplifier boasting high driving power, supported by a strong power supply unit typical of Sansui. The sound is soft and transparent, yet also has firm, thick bass. The sophisticated design is also attractive. There is rust on the exterior and back of the top plate, and a feeling of use such as dullness and abrasions can be seen (Kobayashi Hitoshi)
Maintenance information: 2024.6.2 maintained (output relay, headphone relay replacement, recouped wire switch due to damage, input selector, etc., switch disassembly polishing grease application (tone, loudness, subsonic, processor, power amplifier direct, source direct, tape, reckout switch), solder repair, each volume, switch cleaning, interior and exterior inspection cleaning, adjustment inspection)
Accessories: none
Main specifications: 130W+130W (8Ω) rated power consumption 330W W471 x H162 x D452 mm weight 23.5 kg
The price has been drastically reduced. 2024/6/2 sales price 278,000 yen Maintained! This α907 limited model is limited to 2000 units. A premain amplifier that stands out for its high SNR and good sound unique to MOS-FET. The fine particle feel in the mid to high range is one of the best in the history of SANSUI premain amplifiers. Coupled with the thick, energetic mid-low range, it is a famous model that has not faded its appeal even now. You can see a feeling of use, such as appearance, dullness, abrasions, etc. (Kobayashi Hitoshi)
Maintenance information: 2024.6.2 maintained (power amplifier direct, etc.) switch disassembly polishing grease application (loudness, subsonic, muting, processor, reckout, MM/MC switch, input selector, source direct, tape), output relay replacement, power amplifier section, power supply transistor, adjustment volume replacement, solder repair, volume, switch cleaning, DC, bias adjustment , running test)
Accessories: copy of instruction manual
Main specifications: 80W+80W (8Ω) MM/MC compatible MOS-FET use W466 × H166 × D453 mm 34 kg
The disposal price has been reduced. Member discounts are not applicable. 2023/6/12 sales price 49,800 yen ※1 mono amplifier only. The display lamp visible through the lattice is a transistor mono power amplifier with an indescribable design. As for the sound quality, it is a powerful sound with a sense of overhang while making you feel thick, and the low frequencies are not sluggish, making you listen to a pleasant sound. The exterior is dull all over, scratches on the top plate, etc., and there is a feeling of use (Kobayashi Hitoshi)
Maintenance information: 2023.6.13 Maintained (output relay contact correction input volume disassembly contact correction protection circuit transistor replacement input terminal polish)
Accessories: none
Main specifications: effective output 150 W, input level adjustment, SNR 110 dB, dimensions W436 x H95 x D328 mm, weight 11.5 kg/1 unit
Maple type. Stand for small speakers made of solid Yonematsu. Compatible with most small speakers. The combination of Corian base and wood block material makes it resonate aggressively and accentuates the sense of spaciousness and depth. You can see a feeling of use, such as appearance, dullness, abrasions, etc. (Kobayashi Hitoshi)
Accessories: 6 spacers
Main specifications: W280 x H615 x D370 mm 6.6 kg
Short plug for balanced input terminals. It can be inserted into an empty input terminal such as an amplifier or D/A converter to achieve a noise reduction effect. An item that also reinforces the back plate of the equipment, enhances damping against external vibrations, and greatly improves sound quality. You can see the exterior, dullness, and feeling of use (Kobayashi Hitoshi)
Accessories: none
Short plug for balanced input terminals. It can be inserted into an empty input terminal such as an amplifier or D/A converter to achieve a noise reduction effect. An item that also reinforces the back plate of the equipment, enhances damping against external vibrations, and greatly improves sound quality. You can see the exterior, dullness, and feeling of use (Kobayashi Hitoshi)
Accessories: none
The disposal price has been reduced. Member discounts are not applicable. 2023/129/7 sales price 5,000 yen. 1 piece only. Phase plug for B&W 800 series. It is probably thought to be machined stainless steel, but details are unknown. How about for those looking for a center speaker such as HTM1 (Murakoshi Yoichi)
Accessories: none
Main specifications: 223g/1 piece
The disposal price has been reduced. Member discounts are not applicable. 2024/4/2 sales price 448,000 yen This is a late C20 model that underwent full maintenance from the 2023/12 condenser to main VOL replacement. Among Mackin's control amplifiers, this is a popular gem with a particularly rich, glossy tone. Not only jazz, but also the vocal sounds are excellent. The unique, rich, and highly artistic tone shows a particularly good compatibility with vintage speakers. Exterior, front panel characters disappear a lot, dullness, small scratches, abrasions, etc., and there is a feeling of use (Kobayashi Hitoshi)
Maintenance information: 2024.4.2 maintenance completed (1/2 W resistor replacement and 3 noise countermeasures replaced) 2023.12.19 maintenance (vacuum tube 6X4, block capacitor, electrolytic capacitor, film capacitor, oil capacitor, resistor, main volume replacement. Gang error correction resistance 1/2 W added, switching noise reduction resistance 1/4 W added. RCA jack and vacuum tube socket caulk repair, operation check.)
Accessories: none
Main specifications: tubular phono 2 system phono equalizer curve variable use vacuum tube ECC83 x 5 ECC82 x 2 EZ90 x 1 W440 x H165 x D316 mm 8.7 kg